The newest tank in Easiway's lineup is a 25-gallon, molded dip tank. This new tank incorporates a ribbed design stabilized by two rigid molded pillars with increased durability to eliminate any bowing in-tank sides.
Special features include a screen hold-down bar to keep screens submerged in the solution while soaking, an in-tank drip ledge to eliminate wasted chemical drag out (not currently seen on any other models in the industry), a sludge catch molded into the bottom of the tank to avoid screens sitting in good and a drain for easy emptying.
This tank will hold 2-3 (23" x 31") frames horizontally OR (20" x 24") frames vertically for easy add/remove.
Threaded Drain Fitting
Built-in drip ledge
Built-in screen hold-down bar
Sludge catch molded into the bottom of the tank
Dimensions & Weight
Volume: 25 Gallons
Outside Tank Dimensions without lid: 37" W x 13" D x 28" H
Outside Tank Dimensions with lid: 38" W x 14" D x 29" H
Inside Dimensions: 33" W x 7" D x 24.75" H
Weight: 37.0 lbs
1:7 Chemical to Water Ratio Using EasiStrip SUPRA
PT525 (25 Gallon Dip Tank)
4 gallons of EasiStrip SUPRA One Step Ink Cleaner & Emulsion Remover
Up to 21 Gallons of Water
Scrape as much ink out of your screen, dip your frame in your tank for 1-3 minutes (just enough time to soften your emulsion), bring it to your washout booth and high pressure rinse both sides of the screen. Your screen will then be ready for the stain-removal process.
Scrape as much ink off of your screen as possible
Place the screen in your dip tank and let it soak for roughly 2-3 minutes
Pull the screen out of the dip tank and allow excess fluid to drain back into the tank
Bring your screen to your washout booth
High Pressure rinse emulsion off of the screen
Apply EasiSolv 701 Screen Wash & Stain Remover (with Degreasers) to both sides of your screen and scrub
High-pressure rinse the excess ink and stains from your screen
Low pressure/flood rinse your screen to remove any excess chemicals from the mesh