Skip to content

Sentri Curable Reducer - 3818

SKU IC3818LF03
Original price $33.50 - Original price $67.00
Original price
$33.50 - $67.00
Current price $33.50
Size: Quart


3818 Sentri Reducer™ works as a soft hand additive.

3818 Sentri Reducer™ works similar to other viscosity-modifying products, but has an improved hand.

3818 Sentri Reducer™ is not a low bleed plastisol and is not recommended for use on poly/cotton dark fabrics.


3818 Sentri Reducer™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing should occur in the dryer.


3818 Sentri Reducer™ can be added to 700 Series, Multipurpose, 1100 Series, 7500 Series, 7500CC, 7600 Series and 900 Series inks as a viscosity modifier or a soft hand additive. Mix with opaque colors to reduce cost and opacity.

For a softer hand, add approximately 10% to 20%, by volume, of 3818 Sentri Reducer™. More may be added, if necessary, without affecting the cure or fusing of themixed ink. The more 3818 Sentri Reducer™ that is added, the less opaque the mixed ink will be.

3818 Sentri Reducer™ is not a low bleed plastisol reducer and is not recommended for use on poly/cotton or 100% poly fabrics that may be prone to dye migration.

Adding any reducers or additives can lower the bleed resistance, opacity, or increase cure times of ink. STIR the ink prior to printing on press and after addition of reducers or additives.

Test dryer temperatures and wash test printed product before and during a production run.